Being a Network administrator its
great and useful to monitor the Network traffic network usages, incoming and
outgoing data in the network, in this post let me point some of the way to do
so.
Hi
everyone, you’re at Intelligent Computing and now as Geek, you’ll be going to
notice the ways how you can Monitor and even analyze the network traffic on
your network by using Linux terminal. You may ask why we need to monitor the
network traffic.
Why you need to monitor the network traffic?
- To check the correct usage of Network and by correct user.
- To maintain the overall network performance to yield best for everyone.
- To monitor Ping, DoS or similar attack and close the ports if needed.
- To see which port using the most of data and managing those holes.
Ways
to Monitor Network traffic by Terminal itself?
1. bmon
bmon
is bandwidth monitor tool and rate estimator for Linux. bmon is portable network
monitor tool you can use in your Linux with many advantages and it will show
you multiple interfaces at once on your terminal.
bmon
support multiple and different type of input and can show you interactive output
of different type and even in many ways.
You
can See complete Man page for bmon and its usage for reference.
2. SLRUM
It
is simple Linux Utility for Resource management; this open source resource is
designed for highly heterogeneous Linux destroy from smallest to supercomputer. You can use this for many purposes, including resource and bandwidth
allocation and management, processor and hardware management and network
management.
3. tcptrack
tcptrack
monitors the TCP connection on Linux based computer/servers, it display the tcp
network stat for given network interface. It monitors the state and display the
information such as IP/Port/bandwidth usage and sorted form.
4. iftop
iftop
works the same way for network as the top work for CPU resource, it can monitor
the network traffic via interface of eth0 or so on. You can see the complete
manual page as well as download and setup instruction on http://www.ex-parrot.com/pdw/iftop/
to install iftop use the following command
sudo apt-get
install iftop
And
run the application by issuing the command,
sudo iftop
And
enjoy.
5. Use the Command tcpdump -i eth0
Eith0,
eth1 are the interfaces of the network or say network adapter, tcpdump –I [interfaces] .
To
see the list of interfaces or network devices you can use the ifconfig command.
Bottom line
You
can use the many installed as well as available tool to monitor your network
for port, data and source and destination analysis. Help others by sharing this
post on social sites, and thanks for reading.
No comments :
Post a Comment